Applied Technology Group, Inc. will design the recommended system topology based on site survey results.
Let our qualified team of RF professionals handle your site survey needs:
Applied Technology Group, Inc. will assist with FCC Licensing issues if required by your application.
Applied Technology Group, Inc. will prepare radio specification for your project.
The contractor/supplier shall install a TY-900, 890-960MHz, 10dBd gain yagi antenna, manufactured by Kathrien-Scala Division, of Medford, Oregon, or equal. The antenna shall be mounted vertically on a 22-Ft, 2-inch galvanized schedule 40 rigid pipe, directed towards the master site ABC, using less than 35-Ft of Heliax LDF4-50, hardline foam coax cable, manufactured by Andrew Corporation of Orland Park, Illinois, or approved equal. The coax cable shall be routed inside the pole using a 12-inch diameter 270-degree loop at the top and clamped with a CGB fitting to support the cable. The connectors shall be an Andrew L4PNM high performance low loss 50-ohm type-N male connector constructed with silver coating and gold center pin, or equal. The coax shall connect directly to the antenna or built in antenna pigtail with no adaptors and using only one connection located at the...
Just like any system, sometimes problems occur that are beyond our control. Applied Technology Group, Inc. offers complete and comprehensive SCADA radio system troubleshooting to help put your system back in top notch operation. Our team of RF professionals will work diligently to isolate the problem and take the corrective action to repair your network.
Applied Technology Group, Inc. offers competitive pricing along with our quality products. While we specialize in select products, we are happy to give you a non-biased opinion and evaluation of competitive products to compare performance levels allowing you to make an informed and sound decision before proceeding with your equipment purchase.
Applied Technology Group, Inc. operates a local repair facility giving you quick turn around for most two-way radios, pagers and select SCADA products. If your products require factory assistance our shipping department will gladly assist you with coordinating factory repairs.
Let our FCC licensed technicians assist you with your on-site field repairs. Contact our RF engineering team to coordinate an appointment. If this is an emergency and your system is down, please let our staff know immediately. We will make every effort to assist you quickly.
Applied Technology Group, Inc. offers daily and monthly radio rentals on stock items. Please contact our office at 661-322-8650 or 800-481-0007 for assistance. Prices vary depending on the product type and length of rental.
Applied Technology Group, Inc., has the latest in programming software available for your equipment. However, sometimes you might need an alternative solution. Check with our technical team to ensure the best software solution for your equipment needs.
Applied Technology Group, Inc. will provide turn-key engineering and custom interfacing for your system specifications. In addition, we will work with all aspects of the project as necessary whether it be with end-users, integrators, engineering firms and contractors. You specify when and where you need us!